白云石制备似立方体状方解石型碳酸钙晶体及其机理研究

以轻烧白云石粉、氯化铵和二氧化碳为原料,在未使用晶型控制剂的情况下,通过蒸氨-沉钙过程制备出了似立方体状碳酸钙。研究了反应温度、溶液中钙离子浓度、通气速率、搅拌速度以及陈化时间对碳酸钙中方解石相含量以及晶体形貌的影响,并探索了沉钙反应的晶型控制机理。结果表明,在反应温度40 ℃、钙离子浓度0.05 mol/L、通碳速率100 mL/min、搅拌速度400 r/min和陈化时间2 h的条件下,制备出形貌规整、粒径分布均匀的似立方体状碳酸钙,平均粒径为5~10 μm。该研究为提升白云石的使用价值、生产高附加价值的碳酸钙产品,以及提高白云石资源的利用率提供理论基础。     

HFIP-Functionalized Co3O4 Micro-Nano-Octahedra/rGO as a Double-Layer Sensing Material for Chemical Warfare Agents

Semiconductor metal oxides (SMO)-based gas-sensing materials suffer from insufficient detection of a specific target gas. Reliable selectivity, high sensitivity, and rapid response–recovery times under various working conditions are the main requirements for optimal gas sensors. Chemical warfare agents (CWA) such as sarin are fatal inhibitors of acetylcholinesterase in the nerve system. So, sensing materials with high sensitivity and selectivity toward CWA are urgently needed. Herein, micro-nano octahedral Co₃O₄ functionalized with hexafluoroisopropanol (HFIP) were deposited on a layer of reduced graphene oxide (rGO) as a double-layer sensing materials. The Co₃O₄ micro-nano octahedra were synthesized by direct growth from electrospun fiber templates calcined in ambient air. The double-layer rGO/Co₃O₄-HFIP sensing materials presented high selectivity toward DMMP (sarin agent simulant, dimethyl methyl phosphonate) versus rGO/Co₃O₄ and Co₃O₄ sensors after the exposure to various gases owing to hydrogen bonding between the DMMP molecules and Co₃O₄-HFIP. The rGO/Co₃O₄-HFIP sensors showed high stability with a response signal around 11.8 toward 0.5 ppm DMMP at 125 °C, and more than 75 % of the initial response was maintained under a saturated humid environment (85 % relative humidity). These results prove that these double-layer inorganic–organic composite sensing materials are excellent candidates to serve as optimal gas-sensing materials.     

Caesium carbonate supported on hydroxyapatite‐encapsulated Ni0.5Zn0.5Fe2O4 nanocrystallites as a novel magnetically basic catalyst for the one‐pot synthesis of pyrazolo[1,2‐b]phthalazine‐5,10‐diones

A novel nanomagnetic basic catalyst of caesium carbonate supported on hydroxyapatite‐coated Ni_0.5Zn_0.5Fe₂O₄ magnetic nanoparticles (Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃) was prepared. This new catalyst was fully characterized using Fourier transform infrared spectroscopy, transmission and scanning electron microscopy, X‐ray diffraction and vibrating sample magnetometry techniques, and then the catalytic activity of this catalyst was investigated in the synthesis of 1H‐pyrazolo[1,2‐b]phthalazine‐5,10‐dione derivatives. Also, Ni_0.5Zn_0.5Fe₂O₄@HAP‐Cs₂CO₃ could be reused at least five times without significant loss of activity and could be recovered easily by applying an external magnet. Thus, the developed nanomagnetic catalyst is potentially useful for the green and economic production of organic compounds. Copyright © 2015 John Wiley & Sons, Ltd.     

The green synthesis of exceptional braided,helical carbon nanotubes and nanospiral platelets made directly from CO2

Helical carbon nanotubes currently cost ~15,000–19,000 USD/kg commercially and are ~10–15 times the price of straight carbon nanotubes of similar dimensions. They have not previously been made from the greenhouse gas CO₂ nor had new variants of the helical morphology been demonstrated. In this study, a novel, inexpensive electrosynthesis of these helical nanocarbon materials from CO₂ is presented. This material may be produced by molten carbon growth conditions that (1) maximize torsional stresses, such as those that may occur during rapid, nucleated carbon reduction, (2) enhance defects that cause formation of heptagonal, rather than the conventional hexagonal building blocks of graphene cylindrical walls, and (3) uniformly control those enhanced defects to repeatedly induce a uniform spiral conformation. These conditions are achieved with at least two of the following experimental conditions: (i) high electrolysis current density, (ii) sp³ defect-inducing agents, such as added oxide, and (iii) controlled concentration of iron added to the electrolyte or cathode. Here, it is shown with SEM, TEM, EDX, XRF, and Raman spectroscopy that a molten controlled electrolyte carbonate synthesis to induce defect formation, and a high rate of electrolysis (0.6 A/cm²) leads to a high yield of helical nanotubes, helical nanofibers, or helical nanoplatelet carbon morphologies.     

大豆脲酶诱导碳酸钙沉淀的多因素影响分析

本文探究了多个影响因素对大豆脲酶诱导碳酸钙沉淀(SICP)的影响,以优选出主要影响因素并提供其最佳范围。首先分析了脲酶浓度和温度对脲酶活性的影响;之后通过正交实验设计,进行25种工况的SICP水溶液实验,研究不同因素组合下Ca²⁺利用率的变化规律;最后借助扫描电子显微镜观测不同工况下生成碳酸钙的形态。结果表明:低温有利于脲酶的保存及活性发挥,5 ℃时脲酶活性能保持21 d以上;同一温度下,脲酶浓度越大,脲酶初始活性越高,脲酶完全失活所需时间越短。pH值、脲酶与胶结液体积比是影响Ca²⁺利用率的主要因素。为达到较高的Ca²⁺利用率,脲酶和胶结液最佳体积比为1,氯化钙与尿素最佳浓度比为1.5,Ca²⁺最佳浓度为1 mol/L。当脲酶浓度较低时生成的六面体状碳酸钙较多;随着脲酶浓度的增大,所沉淀的碳酸钙向球形转变。大豆中富含的天冬氨酸是控制碳酸钙形态的重要因素。     

New dialkylenetriamine zinc complexes as highly efficient ROP catalysts

1. Download : Download high-res image (54KB)
2. Download : Download full-size image

     

Synthesis of highly functionalized selenophenes via a three-component condensation

Abstract

Reaction between arylidenemalononitriles and dimethyl acetylenedicarboxylate in the presence of KSeCN at room temperature provided a simple and efficient one-pot route for the synthesis of highly functionalized selenophenes. The reaction is characterized by mild conditions, short reaction time, and tolerance to various functional groups.     

Facile preparation and synergy study of DMC/ZnGA composite catalyst for the synthesis of oligo (propylene‐carbonate) diols

To overcome the weak carbon dioxide (CO₂) conversion ability of Zn‐Co double metal cyanide (DMC) catalyst, zinc glutarate (ZnGA) catalyst was introduced into the DMC catalytic system and applied for the synthesis of oligo (propylene‐carbonate) diols. The DMC/ZnGA composite catalyst (mass ratio = 10:1) exhibited an excellent synergistic effect which had enhanced CO₂ activation ability, high yield and good selectivity. In copolymerization process, ZnGA catalyst not only provided activated CO₂ for DMC catalyst, but also transferred the propagating chain with more alternating structures to DMC catalyst. Both of the two effects increased the carbonate content in the final products. Overall, DMC catalyst dedicated to the polymer chain growth, while the increased CO₂ conversion mainly attributed to ZnGA catalyst. Oligo (propylene‐carbonate) diols with carbonate unit content of 45.1 mol%, Mn of 1228 g/mol, W_PC of 4.3 wt% and high yield of 1689 g/g _cat was obtained.     

Bilayer Cylindrical Conduit Consisting of Electrospun Polycaprolactone Nanofibers and DSC Cross‐Linked Sodium Alginate Hydrogel to Bridge Peripheral Nerve Gaps

Herein, a bilayer cylindrical conduit (P‐CA) is presented consisting of electrospun polycaprolactone (PCL) nanofibers and sodium alginate hydrogel covalently cross‐linked with N,N′‐disuccinimidyl carbonate (DSC). The bilayer P‐CA conduit is developed by combining the electrospinning and outer–inner layer methods. Using DSC, as a covalent crosslinker, increases the degradation time of the sodium alginate hydrogel up to 2 months. The swelling ratio of the hydrogel is also 503% during the first 8 h. The DSC cross‐linked sodium alginate in the inner layer of the conduit promotes the adhesion and proliferation of nerve cells, while the electrospun PCL nanofibers in the outer layer provide maximum tensile strength of the conduit during surgery. P‐CA conduit promotes the migration of Schwann cells along the axon in a rat model based on functional and histological evidences. In conclusion, P‐CA conduit will be a promising construct for repairing sciatic nerves in a rat model.     

Efficient synthesis of multiply substituted furans using BF@Propyl/dopamine/Pd as a green catalyst

One of the commonly used methods to synthesize furans is the three-component reaction among aromatic aldehyde, arylamine, and acetylenedicarboxylate. The main advantages of this work are easy reaction work-up, short reaction time, high yield and easy recyclability, reusability of the catalyst. And also basalt fiber applications are surely innovative in many industrial and economic fields, because of its good mechanical, chemical and thermal performances.